XUGUANG WANMA
Blog Center
06
2024
-
09
Daily Maintenance of Plastic Parts of Motorcycle Appearance
Author:
Most of the shells of motorcycles are made of ABS plastic products, (especially scooters) are beautiful in appearance and exudes a strong modern atmosphere. However, after some motorcycles are used for a long time, the paint film on the outer surface directly irradiated by the strong light is easy to crack (such as the front of the scooter, the upper part of the rear and both sides), etc.
The main factors affecting the film cracking of ABS plastic products are improper selection of casting molding process parameters, no strict treatment before coating, improper use, etc. However, during use, preventive measures should also be taken for maintenance.
The winter temperature in most parts of China is below 0, the temperature in some parts of the north is -20, and the lowest temperature in some areas is -35. Using a motorcycle under low temperature conditions will not only cause difficulty in starting the engine, increase fuel consumption, and increase parts wear, but also cause great damage to the motorcycle shell if it is not properly maintained. If the motorcycle is parked in the open air below 0 for a long time, ABS plastic parts will crack in the whole depth, and if it is below -40, it will be completely embrittled.
Therefore, motorcycles should be stored indoors as much as possible. If there is no condition to store outdoors, it should be covered with prefabricated panels to prevent moisture intrusion. It is best to put a motorcycle cover on them to facilitate heat preservation. It should also be noted that when the weather is fine, the motorcycle cover should be removed to drive away moisture.
Latest Blog
2024-09-06
What are the motorcycle lamps?
Motorcycle lamps mainly include headlights, turn signals, tail lights, position lights/width indicators, instrument lights, reversing lights, brake lights
2024-09-06
Analysis on Production Process of Automobile Injection Molding Parts
There are many kinds of raw materials for automobile injection molding parts, including plastic, rubber, glass fiber, etc.
2024-09-06
Injection Molding Process of Automobile Injection Molding Parts
The first step in the production of automotive injection molded parts is the pretreatment of plastic particles.